Aspire Spryte AIO Kit
Aspire Spryte AIO Starter Kit
Another great AIO pod system from Aspire, the Spryte AIO. An all new design pod system, slim and stylish, it comes in 5 popular, satin finish, stylish colors: olive green, grey, black, blue and pink. The Spryte has an easy to fill 3.5 or 2mL pod, it fits comfortably in the hand in use and is very discreet. It utilizes Aspire’s well known BVC coils and comes with a regular 1.8 ohm coil and a second one 1.2 ohm for use with nicotine salts.
- Dimensions: 108 x 26 x 26mm
- Pod Capacity: 3.5/2.0mL
- Output Wattage: 12W
- Battery: 650mAh built-in
The Spryte's sleek minimalist design fits well in your pocket or purse and the protective cap fits snugly onto the bottom of the device when in use.
Although unusual for an AIO pod device of this type, the Aspire Spryte has an adjustable airflow system to suit your vaping preferences.
The Aspire Spryte atomizer is the well known and trusted BVC coil and uses nichrome wire. The Spryte comes with two coils, one for regular e-liquid and one for use with nicotine salts, though it works well with normal e-liquids as well.
The pod in the Aspire Spryte is an easy to use pull-out - push and click system. It is bottom fill, using a simple but effective silicon plug in the base of the pod, with a generous 4.6mm filling hole to suit all types of e-liquid bottles.
Coil Installation: Whatever type of coil you use, the standard BVC or the nic-salts BVC, both are easy to install. Simply remove the pod and turn it upside down, remove the chimney unit and screw in your chosen coil. Replace the chimney unit with attached coil and reinsert into the pod. Push the pod back into the Spryte until it clicks. Note: when inserting a new coil and filling the pod, always let the device stand for 5 minutes to allow the coil to become saturated. This will help avoid dry hits and damage to the coil.
Filling the Pod: Refilling the pod is super easy. Remove the pod from the device, invert the pod and remove the silicone plug from the 4.6 diameter filling hole. Fill the pod with e-liquid, and replace the silicone plug securely. Replace the pod into the device by pushing down until it clicks into place, and it’s ready.
Charging: Charging the Aspire Spryte is also very simple. Just plug in the supplied micro USB cable into the base of the mod, attach the other end to a suitable power supply to charge. The maximum charge current can reach up to 1000mA. When attached to the usb with the power on the LEDs will flash blue and red three times, when fully charges the LEDs will flash blue and red twenty times then remain off.
- 1 x Spryte Device
- 2 x Extra O-Rings
- 2 x Coils (1.8 ohm regular & 1.2 ohm for nic salt)
- 1 x Silicone Seal
- 1 x Micro USB Cable
- 1 x Warranty Card
- 1 x User Manual